This website uses its own and third party cookies to collect information in order to improve our services. If you keep browsing, that implies the acceptance to install them. The user can configures his browser, avoiding to install the cookies in his hard disk, but should be aware that this action may cause difficulties of navigating on the website. How to configure Accept


Rod Position Limit Switch

Limitadores de Posición

7551 and 7552 position limit switches are designed for the control of complex operating equipment. As they are control auxiliaries, they act on a power interface.

The choice of materials, technical solutions and ample size make these limit switches ideal for use in strongly aggressive environments where they are exposed to the most severe operating conditions, guaranteeing impeccable function at all times and for their entire life.

The enclosure is made of die-cast aluminum alloy and is resistant to any violent impact, chemical aggression and rust, while the bushings in sinterized material eliminate the need for any operations of routine maintenance of the header, since they are also made of impact-resistant zama.

7551 and 7552 limit switches are equipped with 4 fastening holes and 3 outputs for wire clamps to reduce installation time and facilitate wiring operations.